本帖最后由 lock794779857 于 2013-12-19 13:58 编辑
电池图
rhino直接输出stl文件,非常给力
不同参数
110.390953mmX97.994696mmX97.994696
打印过程
打印参数:; generated by Slic3r 0.9.8 on 2013-12-18 at 14:01:10
; layer_height = 0.4
; perimeters = 2
; top_solid_layers = 3
; bottom_solid_layers = 3
; fill_density = 0.4
; perimeter_speed = 30
; infill_speed = 60
; travel_speed = 130
; scale = 1
; nozzle_diameter = 0.5
; filament_diameter = 3
; extrusion_multiplier = 1
; perimeters extrusion width = 0.53mm
; infill extrusion width = 0.53mm
; support material extrusion width = 0.53mm
; first layer extrusion width = 0.80mm
20:56:22.927 : 任务结束在 2013/12/18 20:56
20:56:22.927 : 打印时间:5小时:49分:42秒
20:56:22.927 : 发送行:400034
|